Leica Biosystems PELORIS_PELORIS II - Manual (Page 68)

Protocol Setup
Leica PELORIS™ User Manual Rev K © Leica Biosystems Melbourne Pty Ltd 2011 68
Selecting Reagents
When you select the Reagent cell in the protocol step table to add or change a reagent the dialog
box you see depends on the reagent selection method.
For all the methods you can show only reagents that are compatible with the preceding protocol
step (for the protocol’s type), or all reagents. For station selection you can hide stations that have
already been selected. If you choose an incompatible or hidden reagent it is added to the protocol
table with an asterisk to indicate that it is disallowed. You cannot load the protocol or run the
protocol.
Group Reagent Selection
If the protocol uses group reagent selection you can see the protocol types configured for the
instrument, but can only select by group.
Figure 41. Reagent selection – Group dialog box
Type Reagent Selection
If the protocol uses type reagent selection you can see the protocol types configured for the
instrument, ordered by group. Select specific types.
Figure 42. Reagent selection – Type dialog box
Tap anywhere on the group
button to select the reagent
group
Show compatible: show
only compatible reagent
groups
Show all: show all reagent
groups
Tap on a type button to select
the reagent type
Show compatible: show
only compatible reagent
groups
Show all: show all reagent
groups