Rockwell Automation 57C570 AutoMax PC3000 User Manual - Manual (Page 105)

7Ć7
7.4.2 Terminating RGĆ11/U Cable
Use the following procedure to install the dual crimp plug connector
onto the coaxial cable:
Step 1.
After the cables have been installed in the conduit or
cable trays, slide the ferrule onto the coax cable as
shown in figure 7.9.
FERRULE
Figure 7.9 Ć Slide Ferrule onto RGĆ11/U Cable
Step 2. Strip the coax using the dimensions shown in figure 7.10.
Be sure the shield braid wire is cut to the correct length
and cannot touch the center conductor.
FERRULE
11 /
16
1 /
2
3 / 16
3 /
8
Figure 7.10 Ć RGĆ11/U (Belden 8213) Cable Stripping Dimensions
Step 3. On the crimping tool shown in figure 7.11, rotate
locator/stop by turning the adjustment cap to the OPEN
position.