Rockwell Automation 57C570 AutoMax PC3000 User Manual User Manual

Page 54

Advertising
background image

3Ć16

3.4.1

DCSĆNET FiberĆOptic Network System

Components

The DCSĆNET fiberĆoptic network system consists of the following

components:

Drop Cable

The drop cable (M/N 57C366) is used to connect the Network

module to the transceiver.

A 9Ćpin DĆshell connector is provided at one end of the 3Ćfoot

(1Ćmeter) cable for connection to the PC3000. Terminations are

provided on the other end of the cable for connection to the

terminal strip on the transceiver.

StandĆAlone

FiberĆOptic

Transceiver

The StandĆAlone FiberĆOptic Transceiver (M/N 57C365) is

required at each slave network drop for connection to the

fiberĆoptic network. (A StandĆAlone Transceiver is required at

the master rack only if the rack and the fiberĆoptic hub cannot

be located together.) It performs the biĆdirectional conversion

between electrical and optical signals. Transceiver technical

specifications are listed in Appendix C.

The transceiver is designed to be panelĆmounted (vertically or

horizontally). Mounting holes are provided on flanges that

extend from both ends of the enclosure. Receive and transmit

ports labeled R" and T", respectively, are provided on one

end of the transceiver for connection to the fiberĆoptic link with

the transceiver hub. The transceiver is shipped with dust caps

covering the fiberĆoptic ports. The dust caps should not be

removed until the fiberĆoptic cables are installed, and should

be replaced if the cables are disconnected, to prevent dust

accumulation and the resulting loss of signal integrity.

WARNING

TURN OFF AND LOCKOUT OR TAG POWER TO BOTH THE

RACK CONTAINING THE NETWORK COMMUNICATIONS

MODULE AND THE TRANSCEIVER (RACKĆMOUNTED OR

STANDĆALONE) BEFORE VIEWING THE FIBERĆOPTIC

CABLE OR TRANSMITTER UNDER MAGNIFICATION.

VIEWING A POWERED FIBERĆOPTIC TRANSMITTER OR

CONNECTED CABLE UNDER MAGNIFICATION MAY

RESULT IN DAMAGE TO THE EYE. FOR ADDITIONAL

INFORMATION,

REFER

TO

ANSI

PUBLICATION

Z136.1Ć1981. FAILURE TO OBSERVE THIS PRECAUTION

COULD RESULT IN BODILY INJURY.

Advertising
This manual is related to the following products: