Rockwell Automation 57C570 AutoMax PC3000 User Manual User Manual
Page 127
10Ć5
10.4.1
Setting Up the Modem That Is Connected to the
AutoMax PC3000
This procedure assumes that the AutoMax PC3000 has its operating
system loaded.
To set up a modem connected to an AutoMax PC3000, follow these
steps:
Step 1.
Run the AutoMax Programming Executive.
Step 2.
From the Online menu, select Online Task Manager.
Step 3.
Select the Connect menu.
Step 4.
Select Baud Rate.
Step 5.
Select the baud rate to match that of the modem you are
connecting to the PC3000.
Step 6.
Exit the Online Task Manager.
Step 7.
Disconnect the cable between the PC3000 and the PC.
Step 8.
Set the modem to use the autoĆanswer mode.
Step 9.
Connect the modem to the telephone line and to Port B.
The cable that connects the modem to the PC3000 uses
straight wiring for pins 2, 3, and 7. For more information
about cables, see Appendix C.
10.4.2
Setting Up the Programming Device's Modem
This section assumes you are using terminal emulation software.
Refer to the software's user manual for specific instructions, and
make sure the modem is set up as follows:
D The modem's baud rate matches that of the modem connected
to the remote PC3000.
D Use these control strings:
D AT & K0 (use no local flow control)
D AT & D0 (ignore status of DTR signal)
After you have set up the modem, do the following:
Step 1.
Use the terminal emulation software to dial the remote
PC3000, and establish a connection.
Step 2.
Run the AutoMax Programming Executive software, and
select Online Task Manager from the Online menu to
connect to the remote AutoMax PC3000.
10.5
Connecting to an AutoMax PC3000
Processor Via the DCSĆNET Network
To connect to an AutoMax PC3000 over the DCSĆNET network, you
must be directly connected to a Processor or PC3000 that has
access to the DCSĆNET network, or you must use a PCĆLink
Interface module connected to the DCSĆNET network.
The Processor you are directly connected to can be an AutoMax
rack with a Network card or another PC3000. You can directly
connect to an AutoMax Processor with a serial cable. You can
directly connect to a PC3000 with a serial cable (when using the