Rockwell Automation 57C570 AutoMax PC3000 User Manual - Manual (Page 125)

10Ć3
10.3 Connecting to the AutoMax PC3000 Via
Port B of the Serial Card
You can use Port B of the AutoMax PC3000 Serial card to connect a
programming device to an AutoMax PC3000. You can use this
connection method for an AutoMax PC3000 Packaged Version or a
serial card housed in a PC chassis.
You need to provide the appropriate serial cable and properly set up
the communication parameters.
Important: Make sure that jumper JP2 is installed on the AutoMax
PC3000 Processor card. Having this jumper installed enables Port
B to function as a programming device port. See figure 10.1.
10.3.1 Using the Correct Cable
Port B of the AutoMax PC3000 Serial card is an opticallyĆisolated
RSĆ232 port with a 25Ćpin female DĆshell connector.
You can order cable M/N 61C127, or you can make your own cable.
Use the following table to help you decide which pin assignment
diagram to reference.
ББББББББ
Б ББББББ Б
ББББББББ
If your programming
device has a:
БББББ
Б БББ Б
БББББ
See figure:
ББББББББ
25Ćpin male DĆshell
БББББ
10.2
ББББББББ
ББББББББ
9Ćpin male DĆshell БББББ
БББББ
10.3
Programming Terminal End
25ĆPin Female Cable Connector
Reliance End
25ĆPin Male Cable Connector
SIGNAL PIN#
RECV ă3
XMIT ă2
CTS ă5
RTS ă4
DTR 20
DSR ă6
COM ă7
PIN# SIGNAL
ă2 XMIT
ă3 RECV
ă4 RTS
ă5 CTS
ă6 DSR
20 DTR
ă7 COM
Figure 10.2 Ć 25Ćpin to 25Ćpin Programming Cable