Rockwell Automation 57C570 AutoMax PC3000 User Manual - Manual (Page 106)

7Ć8
FRONT OF
TOOL
ADJUSTMENT CAP
INTEGRAL
CRIMPING
DIES
FERRULE
CRIMPING
AREA
RATCHET
Figure 7.11 Ć Turn Adjustment Cap to OPEN Position
Step 4. Insert the conductor into the contact wire barrel until the
contact butts against the cable dielectric, and place the
contact in the tool head as shown in figure 7.12.
END OF CONTACT
MUST BE LOCATED
IN LOCATORĆSTOP
RECESS
Figure 7.12 Ć Place Contact in Tool Head