Rockwell Automation 57C570 AutoMax PC3000 User Manual - Manual (Page 95)

6Ć3
To mount the AutoMax PC3000, follow these steps:
Step 1.
Mark the locations of the bracket holes on the panel.
Make sure to leave the following space:
D 22.9 cm (9 in.) next to the connectorĆside of the
chassis to provide space for attaching the cable
connectors
D 22.9 cm (9 in.) below the chassis fan to provide space
for changing the filter and for air circulation
Use Figure 6.1 as a guide.
Step 2. Secure the PC3000 to the panel with four #10Ć32 screws.
6.4 Grounding the AutoMax PC3000 Packaged
Version
When grounding the AutoMax PC3000, comply with the electrical
code of the country where the equipment is or will be installed as
well as the appropriate international, national, and local standards,
codes, and ordinances.
Connect a ground wire to the GND" terminal on the input power
terminal block or to the ground terminal below the terminal block.
6.5 Connecting Power
Connect incoming power to the terminal strip on the PC3000
industrialized chassis. See figure 6.2 for details.
L
N
F.G
20839ĆM
BLUEĆLINE
WHITEĆNEUTRAL
PROTECTIVE
EARTH
Figure 6.2 Ć Connecting Incoming Power
Open the chassis door and remove the paper strip covering one end
of the battery, which is installed on the PC3000 Processor card.
6.6 Turning on the AutoMax PC3000
Once you have connected power to the AutoMax PC3000 Packaged
Version, turn it on by using the power switch on the chassis.