Rockwell Automation 57C570 AutoMax PC3000 User Manual - Manual (Page 135)

11Ć7
JP2
JP5
20819ĆM
When the jumper is off, the
ISA Bus is used as the programming
device connection. (Default setting for
PC3000 Processor cards shipped
individually.)
When the jumper is ON, Serial Port B
on the AutoMax PC3000 Serial card
is used as the programming device
connection. (Default setting for the
PC3000 Packaged Version.)
JP2
JP4
Figure 11.7 Ć Removing Jumper JP2 on the AutoMax PC3000 Processor Board
11.2.2 Using the Correct Cable
This section provides information about the pin assignments for Port
B as well as examples of some typical cable wiring.
Table 11.2 lists the pin assignments for Port B. The cable you connect
to Port B should have a 25Ćpin male connector that is properly wired.