Rockwell Automation 57C570 AutoMax PC3000 User Manual - Manual (Page 151)

13Ć1
13.0 CONFIGURING THE
AutoMax PC3000 AĆB
REMOTE I/O SCANNER
For information about: See this section:
About Configuring the AutoMax PC3000 Scanner Interface 13.1
Configuring the Remote I/O Racks
13.2
Configuring the I/O Scanner by Assigning Variable Names
to the Scanner Setup and Status Table
13.3
AutoMax PC3000 Scanner Configuration Example 13.4
What to Do Next 13.5
13.1 About Configuring the AutoMax PC3000
Scanner Interface
The PC3000 scanner is most easily configured using its Variable
Configurator form, which is available in the AutoMax Programming
Executive V4.1A and later. Zooming into" the module gives you
access to the module's registers and bits. From there you use these
views" to configure the module:
Figure 13.1 Ć Available Views for the PC3000 Scanner
Variable Configurator Form
Use chapters 13 and 14 to determine the registers and bits to use.
Also, use the Microsoft Excel  spreadsheet ABWKSH.XLS provided
with the Programming Executive as a worksheet to record assigned
variable names.
NOTE: Data you enter in the spreadsheet cannot be imported into
the AutoMax Programming Executive software.