Rockwell Automation 57C570 AutoMax PC3000 User Manual - Manual (Page 3)

PĆi
PREFACE
This section describes the purpose, intended audience, and scope
of this manual. Some terminology used in this manual is also
discussed.
Purpose of This Manual
This manual is intended to help you:
D install, configure, and maintain the AutoMax PC3000, including
the AutoMax PC3000 Packaged Version
D plan, design, install, and maintain the AutoMax DCSĆNET
network and the AllenĆBradley Remote I/O link
D understand how to structure your application programs
D write application programs for initializing the AutoMax PC3000
remote I/O scanner interface and block transferring data to
AllenĆBradley remote blockĆtransfer modules
Intended Audience
This manual assumes an understanding of the:
D AutoMax DCS processors
D AutoMax Programming Executive software
D AllenĆBradley Remote I/O
D control system application and theory
Terminology Used in This Manual
ББББББББББ
ББББББББББ
This term:
БББББББББББ
БББББББББББ
Refers to the:
ББББББББББ
Б ББББББББ Б
ББББББББББ
PC3000
БББББББББББ
Б БББББББББ Б
БББББББББББ
AutoMax PC3000 Processor card or
the AutoMax PC3000 Packaged VerĆ
sion
ББББББББББ
AutoMax PC3000 Processor card
БББББББББББ
M/N 57C560
ББББББББББ
ББББББББББ
AutoMax PC3000 Serial card БББББББББББ
БББББББББББ
M/N 57C565
ББББББББББ
Б ББББББББ Б
Б ББББББББ Б
ББББББББББ
AutoMax PC3000 Packaged Version БББББББББББ
Б БББББББББ Б
Б БББББББББ Б
БББББББББББ
M/N 57C570
AutoMax PC3000 Processor card and
Serial card installed in an industrialĆ
ized chassis.
For definitions of more terms, refer to the Glossary located in the
back of this manual.