Rockwell Automation 57C570 AutoMax PC3000 User Manual User Manual
Page 225
20Ć7
ББББББББББ
ББББББББББ
ББББББББББ
Installing the card into a PC
chassis:
БББББББББББ
БББББББББББ
БББББББББББ
Installing the card into an PC3000
Packaged Version:
БББББББББББ
Б
БББББББББ
Б
Б
БББББББББ
Б
Б
БББББББББ
Б
Б
БББББББББ
Б
Б
БББББББББ
Б
БББББББББББ
Step 7.
Reconnect incoming
power, and turn on the
AutoMax PC3000
Packaged Version.
ББББББББББ
Б
ББББББББ
Б
Б
ББББББББ
Б
Б
ББББББББ
Б
Б
ББББББББ
Б
Б
ББББББББ
Б
ББББББББББ
Step 7.
Boot into Windows 95, and
adjust the card's setting in
the Device Manager. If a
single PC3000 Processor
card is installed in a PC,
follow the procedures in
section 5.4. If multiple
PC3000 Processor cards
are installed in a PC, follow
the procedures in section
5.8.
БББББББББББ
Б
БББББББББ
Б
Б
БББББББББ
Б
Б
БББББББББ
Б
Б
БББББББББ
Б
БББББББББББ
Step 8.
Configure the card by
loading the operating
system and setting the
DCSĆNET network drop
number to that of the card
you removed.
ББББББББББ
Б
ББББББББ
Б
Б
ББББББББ
Б
Б
ББББББББ
Б
Б
ББББББББ
Б
ББББББББББ
Step 8.
Configure the card by
loading the AutoMax
PC3000 operating system
and setting the DCSĆNET
network drop number to
that of the card you
removed.
БББББББББББ
For more information about:
ББББББББББ
See:
БББББББББББ
Б
БББББББББ
Б
БББББББББББ
downloading the operating system
ББББББББББ
Б
ББББББББ
Б
ББББББББББ
the AutoMax Programming
Executive software instruction
manual
БББББББББББ
Б
БББББББББ
Б
Б
БББББББББ
Б
БББББББББББ
setting the DCSĆNET network drop
number
ББББББББББ
Б
ББББББББ
Б
Б
ББББББББ
Б
ББББББББББ
chapter 12
20.4
Removing the old AutoMax PC3000
Processor Card from the Device Manager
(Only for a PC3000 installed in a PC chassis)
Before you physically remove an AutoMax PC3000 Processor card
from a PC chassis, remove the card from the Device Manager list
and remove any references to it in the SYSTEM.INI and
CONFIG.SYS files.
If you have more than one PC3000 Processor card installed in the
PC chassis, you need to know the serial number and memory
address of the card you want to remove. You can find this
information through the Communication Setup dialog box in the
Programming Executive software. The serial number, memory
address, and the name you have assigned it are listed in the fields.
Temporarily record this information.