Rockwell Automation 57C570 AutoMax PC3000 User Manual - Manual (Page 94)

6Ć2
6.2 Wiring Considerations
DANGER
USERS ARE RESPONSIBLE FOR CONFORMING WITH THE NATIONAL
ELECTRICAL CODE AND ALL OTHER APPLICABLE LOCAL, NATIONAL, AND
INTERNATIONAL CODES. WIRING PRACTICES, GROUNDING, DISCONNECTS,
AND OVERĆCURRENT PROTECTION ARE OF PARTICULAR IMPORTANCE.
FAILURE TO OBSERVE THIS PRECAUTION CAN RESULT IN SERIOUS BODILY
INJURY OR LOSS OF LIFE.
To reduce the possibility of electrical noise interfering with the
proper operation of the control system, exercise care when installing
the wiring from the system to the external devices. For detailed
recommendations, refer to IEEE 518.
Refer to chapter 4 for wiring and grounding recommendations when
connecting to AllenĆBradley remote I/O devices.
See Appendix B for information about installing a PC3000 to meet
CE compliance requirements.
6.3 Mounting the AutoMax PC3000 Packaged
Version
You can mount the AutoMax PC3000 Packaged Version on a panel
in an enclosure. Figure 6.1 shows the dimensions of the AutoMax
PC3000 Packaged Version.
305.0 mm
12.0 in.
282.0 mm
11.10 in.
196.0 mm
7.72 in.
180.6 mm
7.11 in.
25.4 mm
1.0 in.
25.4 mm
1.0 in.
10Ć05.2
8Ć010
20836ĆM
Figure 6.1 Ć Mounting Dimensions for the AutoMax PC3000 Packaged Version