Rockwell Automation 57C570 AutoMax PC3000 User Manual - Manual (Page 23)

1Ć3
The AutoMax PC3000 AĆB Remote I/O Scanner connection enables
the AutoMax PC3000 to control any piece of hardware that can
communicate over the AĆB Remote I/O Network, including:
D bulletin 1771, 1791, and 1794 I/O
D PanelView
 Operator Interface terminals
D RediPANEL  stations
D 1336 Plus and Force drives
The AĆB Remote I/O network connection, when used in concert with
the AutoMax DCSĆNET network, lets you create lowĆcost,
highĆperformance drive systems with many features found in
AutoMax systems. You can control one or multiple drives,
depending on the physical length of the network and the level of
performance required.
The AutoMax PC3000 does not support the following standard
AutoMax Multibus features:
D MultiĆprocessing
D Distributed Power System
D Communication Processors, other than the AutoMax DCSĆNET
network
1.2 About the AutoMax PC3000 Processor
Card
The AutoMax PC3000 Processor card combines most features from
the following AutoMax products into a single, ISA bus compatible
printed circuit board:
D AutoMax 7010 Processor
D AutoMax DCSĆNET network
D AutoMax AĆB Remote I/O Scanner
The onĆboard lithium battery and a super capacitor protect the
PC3000 Processor card from memory loss during power failures.
LEDs on the card help you troubleshoot the networks.
Figure 1.2 illustrates the features of the AutoMax PC3000 Processor
card.