Rockwell Automation 57C570 AutoMax PC3000 User Manual - Manual (Page 80)

5Ć2
5.2 Installing the AutoMax PC3000 Processor
Card
An AutoMax PC3000 Processor card requires two adjacent, fullĆsize
expansion slots in a PC chassis.
To install the card into a PC chassis, you must:
D prepare the computer
D install the card in a fullĆsize expansion slot
5.2.1 Preparing the Computer
Before you can install the card, you must prepare the computer. You
need a screwdriver for this procedure. Follow these steps, but refer to
the computer's user manual for detailed instructions about installing
optional cards.
Step 1.
Make sure the computer is off. Disconnect the power cord.
Step 2. Remove the computer's cover.
Step 3. Find two, free, fullĆsize expansion slots that are adjacent to
each other. If you do not know which slots to use, see the
computer's user manual.
Step 4. Remove the slot cover's screw by using a screwdriver, and
remove the slot cover.
5.2.2 Installing the AutoMax PC3000 Processor Card
To install the card, follow these steps:
Step 1.
Remove the card from its shipping container and from its
antiĆstatic bag. Be careful not to touch the components or
the surface. Refer to section 5.1 for more information.
Step 2. Temporarily record the serial number of the Processor
card you are installing. Knowing the serial number of each
AutoMax PC3000 Processor card is important when you
are installing more than one in a PC. The serial number is
printed on a white tag locatedon the upperĆright portion of
the card.
Step 3. Set Jumper JP2 according to Figure 5.1.