Rockwell Automation 57C570 AutoMax PC3000 User Manual - Manual (Page 269)

FĆ1
Appendix F
Using the Sample AutoMax Configurations and Programs
Included on the AutoMax Programming Executive V4.1 software application disk
are sample configurations and programs that you can copy and customize for
your AutoMax PC3000 application. These samples are intended to provide you
with only a starting point as you create logic customized for your application.
The samples are structured according to this model:
D An AutoMax PC3000 supervises the FlexPak 3000 DC and GV3000 AC
drives. These drives are connected to the PC3000 via the DCSĆNET
network. The PC3000 acts as the network master.
D The same AutoMax PC3000 controls a 1794, Flex, I/O remote rack and a
remote PanelView operator interface. These devices are connected via the
Remote I/O network.
D The PanelView operator interface displays data from the FlexPak 3000 and
GV3000 drives and the Flex I/O.
D Operator input from the PanelView is sent to the FlexPak 3000 and
GV3000 drives and the Flex I/O remote rack.
The sample configurations include:
D a basic configuration for the FlexPak 3000 DC drive and GV3000 AC drive
each using the DCSĆNET network option board
D AĆB remote I/O scanner configuration for:
D 1794 (Flex) I/O
D 1791 (Block) I/O
D PanelView operator interface
D Block transfer configuration for transferring data from the PanelView
operator interface to the drives and Flex I/O
The sample programs include:
D an initialization program for the AĆB remote I/O scanner
D a program that flashes lights on the Flex I/O and PanelView operator
interface
D programs that transfer configurations to the FlexPak 3000 and GV3000
drives
D programs that interlock I/O in the FlexPak 3000 and GV3000 drives
BASIC, Ladder Logic, and Control Block languages were used to create the
programs.
For information about: See this page:
Getting Started FĆ2
Using the Sample Configurations FĆ2
Using the Sample Programs FĆ4