Metrohm 746 VA Trace Analyzer - Manual (Page 423)

5.7 Program instructions
746 VA Trace Analyzer / 747 VA Stand
5-272
REM Page: O, S Stand: M, A Abbreviation: RE
Instructions t/s Main parameters Auxiliary parameters
––––––––––––– ––––– ––––––––––––––––––––––––– –––––––––––––––––––––––––
## .. REM ..... ....................................................
Function Remarks or comments line.
Parameter Range; Default value / Meaning
Remark 52 characters; -
Remark
All numbers, letters and characters available on the keypad can be
entered, in addition the entry of all ASCII characters with decimal code
032
… 255 is possible (see section 5.2.3). The entry of the special
characters with decimal code 000 … 031 is not allowed as they are used
as control characters for the printer
Description The REM instruction is used for the entry of remarks and comments in
programs.
Comments • If a remark should be put out on the screen as a message during the
program run, the
HOLD instruction must be used for this.
• If a remark should be printed out on the printer during the program
run, the
PRINT instruction must be used for this.
• If a remark should be printed out on an external printer attached to
one of the two RS232 interfaces, the
SEND>RS1 or SEND>RS2 instruc-
tion must be used.
see also HOLD, PRINT, SEND>RS1, SEND>RS2