Metrohm 746 VA Trace Analyzer - Manual (Page 451)

5.7 Program instructions
746 VA Trace Analyzer / 747 VA Stand
5-300
Description The SWEEP instruction starts the voltage sweep defined in the parame-
ters.
U
t
U.start
U.end
U.step
t.step
Comments • The electrode type must be defined before the SWEEP instruction.
Admissible are DME , SMDE , HMDE or RDE .
• The measurement mode must be defined before the SWEEP
instruction. Admissible are DCTMODE , DPMODE , AC1MODE , AC2MODE or
SQWMODE , but not PSAMODE or CYCMODE .
• Apart from the SWEEP instruction, no other SWEEP instruction is
allowed in the same segment.
• If the final voltage U.end should not be switched off at the end of the
program, enter a suitable standby voltage U.standby in a ØMEAS
instruction.
• With the SWEEP instruction maximum 1000 measured values can be
recorded.
see also DSWEEP, FSWEEP, SSWEEP, DME, SMDE, HMDE, RDE