Leprecon LP-X24 Manual v3.2 - Manual (Page 122)

118 Chapter Five Advanced Programming and Editing Techniques
LP-X24 and LP-X48 Users Manual
Moving and Deleting Looks in a Scene List
To Move a Look in a Scene List
Sometimes some aspect of a scene list must be changed. For example, you may need
to add a new look between what are currently steps 1 and 2. In some instances, it's
easiest to re-record the entire scene list. In other instances, it's easiest to record the new
look at the end of the scene list and then move it into the correct place.
1. Put the board into Edit/Playback mode.
2. Using the side wheel, select a scene list.
3. Press the Edit softkey.
4. Using the side wheel, select a look to move.
Erase Time Move Move Unloop
1
2
3
4
Hold
INF
Edit Scenelist
Note that the Move Up softkey is not available when the first look is selected and the
Move Down softkey is not available when the last look is selected.
5. Press the Move Up or Move Down softkey to move the selected look into the
desired position.
Erase Time Move Move Unloop
1
2
3
4
Hold
INF
Edit Scenelist
6. Repeat steps 4 and 5 until all looks are moved into the desired positions.