Leprecon LP-X24 Manual v3.2 - Manual (Page 159)

Stacks Chapter Ten 155
LP-X24 and LP-X48 Users Manual
Button/Fader Setting
Filter N/A
Bump Any setting
Master Fader Up (typically full on)
Manual Fader Any setting
Programmer Fader Down (typically zero)
Stack Fader At either 0% or 100%
2. Turn on the stack by pressing the stack's On button.
Stack Status: ACTIVE Manual
Change
Out:
In:
Next:
0.0
0.0
1.0 Fade: 100%
Fade: 0%
Out shows the number of the outbound step and the percentage it has faded down.
In shows the number of the inbound step and the percentage it has faded up.
Next shows the number of the next step.
3. To play back the first step using the stack's Cross Fader, move the fader from one
end of the fader's travel to the other.
Stack Status: ACTIVE Manual
Change
Out:
In:
Next:
0.0
1.0
2.0 Fade: 58%
Fade: 42%
4. To play back the first step using the buttons, press the Go button.