Leprecon LP-X24 Manual v3.2 - Manual (Page 168)

164 Chapter Ten Stacks
LP-X24 and LP-X48 Users Manual
Inten Color Beam Focus
Intensity
Color
Beam
Focus
Edit Scene Timing Hold
0:10.0
Fade
0:00.0
0:00.0
0:00.0
0:00.0
Delay
0:00.0
0:00.0
0:00.0
0:00.0
5. Using the left wheel or the softkeys, select a property.
Note that settings for Intensity will be saved but will not affect the stack.
6. Using the center wheel, adjust the delay for the selected property.
This setting will determine how much time will pass from the start of the stack step
until the property's value changes. For example, you might want the moving lights to
move into their new position and then change color. To accomplish this, you would
change the delay for Color to 5 seconds and leave the delay for the Focus set to
zero.
You may also set the delay by pressing the center wheel, entering the desired value
on the numeric keypad and then pressing the Enter key.
7. Using the right wheel, adjust the Fade for the selected property.
This setting will determine how much time will pass from the time the property begins
to change until it is done. For example, you might want the moving lights to move
into their new position gradually rather than snapping to it. To accomplish this, you
would change the Fade for Focus.
You may also set the fade by pressing the right wheel, entering the desired value on
the numeric keypad and then pressing the Enter key.
8. When you are done, press the Yes button.
Advanced Techniques
To Change Step Links
You may have a reason to change the order in which steps will be executed. For
example, you may be skipping over a portion of a performance during the day's
rehearsals. The LP-X provides an easy way to change step linkage.
1. Put the LP-X in Edit and Stack mode.
The LP-X displays the Edit Stack screen.
2. Use the side wheel or the Plus (+) and Minus (-) keys to select a step to re-link.