Leprecon LP-X24 Manual v3.2 - Manual (Page 91)

Moving Light Programming Chapter Four 87
LP-X24 and LP-X48 Users Manual
Button/Fader Setting
Modes Record and Scene
Display ML
Filter
ML or BOTH
Bump Any setting
Master Fader Up (typically full on)
Manual Fader Any setting
Programmer Fader Up
The LP-X displays the Moving Light Programmer.
Label
Recording new scene
ColrFx Beam Attrib Focus
No instruments selected.
Delay
0:00.0 Fade
0:00.0
100%
Dowse
Intensity:
The first time you enter this mode, the LP-X informs you that no instruments are
selected.
Selecting Moving Lights for Programming
A light can be in one of three states. It can be:
• in the look and selected for programming
• in the look but not selected for programmingdeselected
• not in the look.
1. To select a light for programming, you press its ML Select button.
ML Select buttons are located under the Manual Faders and are assigned when
you add the light to the instrument list. For details, please see "To Add a Moving
Light Instrument into the System" beginning on page 45.
• The first time you press the ML Select, the light is added to the look and is
selected for programming. This is indicated by a blinking LED in the ML Select.
• The second time you press the ML Select, the light remains in the look but is
deselected for programming. This is indicated by a glowing (not blinking) LED in
the ML Select.