Leprecon LP-X24 Manual v3.2 - Manual (Page 83)

Conventional Light Programming Chapter Three 79
LP-X24 and LP-X48 Users Manual
Edit: PG 1 PB 6 Step: 1
Save
Select
Level
Fade
0:00
FF
01 02 03 04 05 06 07 08 09 10 11 12
13 14 15 16 17 18 19 20 21 22 23 24
25 50
4. Press the Save softkey.
5. Repeat steps 2 through 4 for each look you want to modify.
6. When you are done, return to Run mode.
7. Optional: Return all Manual Scene Faders to the desired levels and then raise the
Manual Fader up from the zero level.
To Modify a Conventional Light Look When You are Running a
Show
Blind Edit
This operation will work on any playback except one that is in page hold mode. For
example, if you are running a scene list on Page 1, Playback 1, you will not be able to
edit a scene list on Page 2, Playback 1. This is because Playback 1 is in page hold
mode and will not switch to Page 2 until the Playback 1 level is brought to zero.
1. Start by ensuring that all buttons and faders are in the proper positions.
Button/Fader Setting
Modes Edit and Scene
Display DIM
Filter DIM
or BOTH. Should be set to BOTH if you have an
moving light information recorded with the scene.
Bump Any setting
Master Fader Up (typically full on)
Manual Fader Down (typically zero)
Programmer Fader Down
The LP-X displays the following message: