Leprecon LP-X24 Manual v3.2 - Manual (Page 202)

198 Chapter Twelve Other Setup Features
LP-X24 and LP-X48 Users Manual
For more information about Stack In Fade and Stack Out Fade, please see "Automating
a Stack" beginning on page 161. For more information about Hold Time, Delay and
Fade, please see "Automating a Show" beginning on page 110.
To Modify Stack In Fade and Stack Out Fade
1. From the Setup Mode screen, press the Default softkey.
The Show Defaults screen appears.
Show Defaults
Stack Out Fade: 0:02:0
Stack In Fade: 0:02.0
Auto Save Interval (minutes): 5
Timing
2. Use the left wheel to select the Stack In Fade or Stack Out Fade.
3. Use the right wheel to increase or decrease the value for your selection.
To Modify the Auto Save Interval
1. From the Setup Mode screen, press the Defalt softkey.
The Show Defaults screen appears.
2. Using the left wheel, select Auto Save Interval (minutes).
3. Using the right wheel, select the desired auto save interval (between 5 and 30
minutes).
To Modify Hold Time, Delay or Fade Defaults
1. From the Setup Mode screen, press the Defalt softkey.
The Show Defaults screen appears.
2. Press the Timing softkey.
The Default Scene Timing screen appears.