Leprecon LP-X24 Manual v3.2 - Manual (Page 138)

134 Chapter Six Creating Moving Light Labels
LP-X24 and LP-X48 Users Manual
2. Press the Color, Beam or Focus softkey.
3. Press the Label softkey.
4. Select the fixture or in the case of Focus labels fixturesfor which you want to edit
a label.
5. Select the label that you want to edit.
6. Press the Edit softkey.
7. Make the desired changes and then press the Save softkey.
Use the procedures given in "To Create a Color or Beam Label" beginning on page
123 or "To Create a Focus Label" beginning on page 127.
To Rename a Label
1. Put the LP-X into the following modes for moving light recording:
Button/Fader Setting
Modes Record and Scene
Display ML
Filter ML
Bump
Any setting
Master Fader Up (typically full on)
Manual Fader Any setting
Programmer Fader Up
The LP-X displays the Moving Light Programmer.
2. Press the Color, Beam or Focus softkey.
3. Press the Label softkey.
4. Select the label that you want to rename.
If you do not see the label, you may need to restrict the instrument selection. The ML
Programmer only shows the labels that the selected instruments share in common.
5. Press the Rename softkey.