Leprecon LP-X24 Manual v3.2 - Manual (Page 170)

166 Chapter Ten Stacks
LP-X24 and LP-X48 Users Manual
The LP-X adds additional information to the screen but continues to execute the
steps of the stack.
2. Using the left wheel, specify which step will come next.
You may also press the left wheel, enter the step on the numeric keypad and press
the Enter key.
3. Using the center wheel, specify how rapidly the new next step will fade in.
You may also press the center wheel, enter the In Fade time on the numeric keypad
and press the Enter key.
3. Using the right wheel, specify how rapidly the active step will fade out.
You may also press the right wheel, enter the Out Fade time on the numeric keypad
and press the Enter key.
4. When you are ready, press the Apply softkey.
The LP-X fades out from the active step at the specified rate and the new "next" step
fades in at the specified rate.
5. Press the Change softkey again to hide the additional run time functions.
Changing Steps at Run Time Short Cut
Use this procedure to quickly change the next step.
1. With the stack playing back from Run and Stack mode, press the Cue button.
2. Using the Numeric Keypad, enter the number of the step that you want to play back
next.
3. Press the Enter key to confirm the operation. Press the Clear key to cancel the
operation.
Linking to a Playback
The LP-X provides the ability to link a look or a chase on a playback to a specific step in
the stack. When the stack step executes, the LP-X automatically starts the chase or
displays the look for the duration of the stack step.
1. Put the LP-X in Edit and Stack mode.
The LP-X displays the Edit Stack screen.
2. Use the side wheel or the Plus (+) and Minus (-) keys to select a step to link to a
playback.
3. Press the Edit softkey.
The LP-X displays the Edit Stack Step X screen (where X represents the number of
the stack step that you selected in step 2).