Lenze ELCAMZIxxx4SNNPSNN (LCU122) - Manual (Page 103)

PROFIsafe on board
Appendix
Consistent parameter data
6

103 EDSLCMX3024-SPS EN 5.0
Configuring consistent data
Consistency is achieved by an appropriate PROFIBUS master configuration. Please refer to
the corresponding instructions for your configuring software for this purpose.

Tip!
Consistency configuration depends on the PROFIBUS master configuring
software. When using a Siemens-S5 PLC, please consider:
ƒ Consistency is switched on by any word in the consistent area
ƒ Consistency must be switched off by a specific switch-off word.
ƒ The type of CPU, consistency and address area determines which word
switches off consistency.