Lenze ELCAMZIxxx4SNNPSNN (LCU122) - Manual (Page 139)

Commissioning
Preconditions
The E82ZBB diagnosis terminal
8

139 EDSLCMX3024-SPS EN 5.0
Altering parameters in the menus
Step Key
sequence
Display Comment Example
1. Inhibit
motor
starter
  Only required if you want to change codes
which are marked with  in the code table,
e. g. C0002
All other parameters can be altered during
operation.
2. Set
parameters
  Increase C0012
(acceleration
time) from
0.50 s to 1.00 s
3.  XXXX Select code 0012
4.  
001 For codes without subcodes: skip to 
(continue with 6.)
5.  xxx Select subcode
6.   0.50 s
7.  XXXXX Set parameter 1.00 s
8.  STOre Confirm entry when is blinking
 Confirm entry when is not blinking; is
inactive
9. Start ”loop” at 2. again to set further
parameters