4 parameter data transfer, Profisafe on board – Lenze ELCAMZIxxx4SNNPSNN (LCU122) User Manual
Page 53
![background image](/manuals/566239/53/background.png)
PROFIsafe on board
Parameter data transfer
6
53
EDSLCMX3024-SPS EN 5.0
6.4
Parameter data transfer
The PROFIdrive parameter data channel (DP-V0, cyclic)
ƒ
enables parameter setting and diagnostics of the motor starter.
ƒ
allows access to Lenze parameters (codes).
ƒ
additionally occupies the first 4 words of the input and output words in the master.
ƒ
has an identical structure for both directions of transmission.
Parameter data is addressed via codes listed in the code table of the corresponding
Operating Instructions for your controller.
Lenze parameter sets
The motor starter features 4 parameter sets, the parameters of which cannot be directly
addressed via the PROFIdrive parameter data channel (DP-V0, cyclic).
Note!
Parameter changes:
Cyclic writing to codes via the PROFIBUS only is permissible if the automatic
parameter set storage of the motor starter (C0003) is deactivated (value 0).
Process data changes:
No automatic storage