Lenze ELCAMZIxxx4SNNPSNN (LCU122) - Manual (Page 9)

Safety instructions
Residual hazards
1

9 EDSLCMX3024-SPS EN 5.0
1.2 Residual hazards
Protection of persons
ƒ The X2x power connector contacts can conduct hazardous voltages if the motor
starter is connected to the mains. Therefore, disconnect the motor starter before
carrying out any work on it.
ƒ The X2x power connector contacts also conduct hazardous voltages when the motor
starter is disabled. Depending on the risk analysis of the machine/system, you may
have to take additional protective measures.
ƒ Operation at ambient temperatures > 40°C:
– The operating temperature of the motor starter housing is > 60°C.
– Depending upon the risk analysis of the machine/system, you may have to use
additional protective covers.
Motor protection
ƒ The connected motor can overheat if
– motors are operated on the motor starter that do not feature temperature
monitoring with PTC thermistor (PTC) or thermal contact (NC contact)
– temperature monitoring with PTC thermistor (PTC) or thermal contact (NC
contact) is not connected to the motor starter
– temperature monitoring is not activated (C0119)
– the set rated motor current for I
2 t monitoring is not adjusted to the motor (C0120)
– I 2 t monitoring is switched off (C0121)