Lenze ELCAMZIxxx4SNNPSNN (LCU122) - Manual (Page 33)

Electrical installation
Safety engineering
5

33 EDSLCMX3024-SPS EN 5.0
Detail characteristics of the safe inputs and safe outputs
Signal
Specification Min. Typ. Max.
I1A, I1B
I2A, I2B
I3A, I3B
I4A, I4B
PLC input, IEC-61131-2, 24 V, type 1
LOW signal
[V] -3 0 5
Input current [mA] 15
HIGH signal [V] 15 24 30
Input current [mA] 2 15
Input capacitance [nF] 3.3
Switch-off time (depending on the standard device) [ms] 2 4
Switch-on time [ms] 2 4
Input delay (tolerated test pulse) [ms] 1
CLA, CLB PLC output, IEC-61131-2, 24 V DC, 50 mA
Supply voltage of the outputs
[V] 18 24 30
LOW signal [V] 0 0.8
HGH signal [V] 17 24 29
Output current [mA] 50
Width of test pulse [μs] 750
Frequency of test pulse [s] 1 1.8 3
Specific resistance of a passive sensor [kΩ] 2
O1A, O1B
O2A, O2B
PLC output, IEC-61131-2, 24 V DC, short-circuit-proof
Supply voltage of the outputs
[V] 18 24 30
Output voltage for LOW signal [V] 0 0.8
Output voltage for HIGH signal [V] 17 24 29
Output current [mA] 500
Width of test pulse [μs] 750 900
Frequency of test pulse [s] 1 1.8 3