Lenze ELCAMZIxxx4SNNPSNN (LCU122) - Manual (Page 150)

Commissioning
Code table
8

150 EDSLCMX3024-SPS EN 5.0
IMPORTANT Possible settings Code
Selection Lenze Designation No.
C0170

TRIP reset
configuration
0 0 TRIP reset by switching the 24 VDC supply
voltage, ”OFF-ON” service switch, via
PROFIBUS or by means of the 
key
z
TRIP reset via PROFIBUS with
C0043, C0410/12 or C0135
bit 11
z Auto TRIP reset resets all
faults automatically after the
time in C0171 has expired
1 As 0 and additionally auto TRIP reset
2 TRIP reset by switching the 24 VDC supply
voltage or via bus function module
3 TRIP reset by switching the 24 VDC supply
voltage
C0171 Deceleration for
auto TRIP reset
0.00 0.00 {0.01 s} 60.00
C0178 Operating hours {h} Read only
Total time of service
switch = ”ON”
C0179 Mains operating
hours
{h} Read only
Total time of mains on
C0200 Software
identification code
82S8215V_xyz00 Read only on the PC
x = main version
y = lower version
C0201 Software creation
date
Read only on the PC
C0202 Software
identification code
Output in the diagnosis terminal as a string in 4
parts with 4 characters each
Diagnosis terminal read only
x = main version
y = lower version 1 82S8
2 215V
3 _xyz
4 00
C0304 Service codes Changes by Lenze service only!
...
C0310
C0370
Service code Changes by Lenze service only!
C0372 Function module
identification
6 PROFIBUS-DP Read only
10 No valid recognition
C0408 Minimum
operating time
0.00 {0.01 s} 20.00 z C0408 can be set differently
in the four parameter sets.
z After a LOW-HIGH edge at Ex,
the digital signal linked with
Ex is active for at least the
time set.
z
Each LOW-HIGH edge during
a running cycle resets the
time.
1 E1 0.00
start043
S (Ex)
S (Ex)
S (Ex)
Ex
Ex
Ex
t C0408
C0408
2 E2 0.00
Ex:
level on E1 or E2
S (Ex):
digital signal linked to E1 or E2