Lenze ELCAMZIxxx4SNNPSNN (LCU122) - Manual (Page 156)

Commissioning
Code table
8

156 EDSLCMX3024-SPS EN 5.0
IMPORTANT Possible settings Code
Selection Lenze Designation No.
C0417

Configuration of
motor starter
status messages (1)
Output of internal digital signals on bus The assignment is mapped to
the
z motor starter status word 1
(C0150)
z
FIF output word 1
(FIF-OUT.W1)
1 Bit 0 1 PAR-B0 active
2 Bit 1 2 Motor starter inhibited
3 Bit 2 3 Status of motor 1
4 Bit 3 4 Status of motor 2
5 Bit 4 5 Status of brake 1
6 Bit 5 6 Status of brake 2
7 Bit 6 7 Error in the power section
8 Bit 7 8 Motor starter enabled/inhibited
9 Bit 8 9 11|10|9|8 Device state
10 Bit 9 10 0011 Operation inhibited
11 Bit 10 11 0110 Operation enabled
12 Bit 11 12 1000 Fault active
13 Bit 12 13 ”Overtemperature” warning
14 Bit 13 14 Manual operation active (plug M12)
15 Bit 14 15 Status of service switch
16 Bit 15 16 Ready for operation
For possible internal digital signals see C0415
C0418
 Configuration of
motor starter
status messages (2)
Output of internal digital signals on bus The assignment is mapped to
the
z controller status word 2
(C0151)
z FIF output word 2
(FIF-OUT.W2)
1 Bit 0 255 Not assigned
... ... ...
16 Bit 15 255 Not assigned
For possible internal digital signals see C0415
C0423 Brake switch-on
delay
0.00 {0.01 s} 20.00 Acts upon brake output only
1 Brake 1 0.00
2 Brake 2 0.00
C0424 Brake switch-off
delay
0.00 0.00 {0.01 s} 20.00 Acts upon brake output only
1 Brake 1 0.00
2 Brake 2 0.00
C0425
 Delay of digital
outputs
0.00 {0.01 s} 20.00 ”Debouncing” of the digital
outputs
z Switches the digital output if
the linked signal is still active
after an adjusted time.
z The reset of the digital output
is effected without delay
z Does not act upon brake
output
1 Digital output A1 0.00
2 Digital output A2 0.00
C0469
 Function of the 
key on the keypad
1 0 No function
1 Inhibit controller