Lenze ELCAMZIxxx4SNNPSNN (LCU122) - Manual (Page 144)

Commissioning
Code table
8

144 EDSLCMX3024-SPS EN 5.0
8.5 Code table

Tip!
The following code table describes the device parameters. The parameters for
the communication via PROFIBUS can be found in chapter 6: ( 84)
How to read the code table
Column
Abbreviation Meaning
Code Cxxxx Code Cxxxx Parameter value is accepted immediately (ONLINE)
1 Subcode 1 of Cxxxx
2 Subcode 2 of Cxxxx
Cxxxx
 Altered parameter of the code is accepted after  has been pressed
Cxxxx
 Altered parameter of the code is accepted after  has been pressed if the controller
is inhibited
uSEr In the Lenze setting, code is available in the uSEr menu. The uSEr menu is active after
every mains connection.
Designation Designation of the code
Lenze Lenze setting (value at delivery or after restoring the delivery status via C0002)
Æ The column ”IMPORTANT” contains further information
Selection 1 {%} 99 Min. value {unit} max. value
IMPORTANT - Short, important explanations
Code Possible settings IMPORTANT
No. Designation Lenze Selection
C0002

uSEr Parameter set
management
0 0 Ready PAR1 ... PAR4:
z Parameter sets of the
standard device
z In PAR1 ... PAR4, C0005,
C0408, C0409, C0410 and
C0411 are individually
adjustable
FPAR1:
z Module-specific parameter
set for PROFIBUS-DP
z
FPAR1 is stored in the
function module