Lenze ELCAMZIxxx4SNNPSNN (LCU122) - Manual (Page 155)

Commissioning
Code table
8

155 EDSLCMX3024-SPS EN 5.0
IMPORTANT Possible settings Code
Selection Lenze Designation No.
C0415

uSEr
(Cont.)
22 Active mains-side rotating field Only active for motor starter
ELCAMZI as of SW 3.4
Clockwise rotating
field
LOW
Anti-clockwise
rotating field
HIGH
23 Error ”Mains failure”
24 Safety engineering active HIGH = motor starter in ”STO”
status (safe torque off)
25 TRIP fault message
26 Motor 1 or motor 2 is running
27 ... 28 Reserved
29
Fixed 0 Signal always is ”LOW”
30 Fixed 1 Signal always is ”HIGH”
31 Reserved
32 Digital input E1
33 Digital input E2
34 Digital input E3
35 Digital input E4
36 ... 39 Reserved
40 ... 55 Reserved
60 ... 75 FIF-IN.W1
Bit 0 (60) ... bit 15 (75)
80 ... 95 FIF-IN.W2
Bit 0 (80) ... bit 15 (95)
100 ...
135
Reserved
160 Level on E1 Level on the digital input
without logic operation or
inversion
161 Level on E2
162 Level on E3
163 Level on E4
255 Not assigned
C0416
 Level inversion of
digital outputs
A1 ... A2
0 0 A1 ... A2 not inverted (HIGH active) C0416 can be set differently in
the four parameter sets.
A combination of the terminals
can be inverted by entering the
sum of the selection values.
1 A1 is inverted (LOW active)
2 A2 is inverted (LOW active)