Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual User Manual
Page 119
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
119
Stratix 5100 Device Manager Parameter Definitions
Chapter 4
Set DataBeacon Rate (DTIM)
These commands let you set the DataBeacon:
ap> enable
ap# configure terminal
ap(config)# interface ________
ap(config-if)# beacon dtim-period <value>
Set Infrastructure SSID
When the access point is in repeater mode, this SSID is used to associate with a parent access point. Check the check box by the pull-down menu
if you want to force infrastructure devices to associate only to this SSID.
Guest Mode/Infrastructure SSID
Settings
Radio0-802.11N2.4 GHz, Set Beacon Mode, single BSSID Multiple BSSID, Set single Guest Mode SSID, Set Infrastructure SSID, Force
Infrastructure Devices to associate only to this SSID.
Table 32 - SSID Manager Parameter Descriptions (Continued)
Parameter
Description