Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual User Manual
Page 473
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
473
Configuring QoS
Chapter 16
This figure shows the Radio Access Categories page. Dual-radio access points
have a Radio Access Categories page for each radio.
Figure 114 - Radio Access Categories Page
Configuring Nominal Rates
When an access point receives an ADDTS (add traffic stream) request from a
WMM client, it checks the nominal rate or minimum PHY rate in the ADDTS
request against the nominal rates defined by the CLI command traffic-stream. If
they don’t match, the access point rejects the ADDTS request.
If you choose Optimized Voice Settings (see
Figure 114 on page 473
), the
following nominal rates are configured:
• 5.5 Mbps, 6.0 Mbps, 11.0 Mbps, 12.0 Mbps, and 24.0 Mbps
For information about the traffic-stream command, see
IMPORTANT
In this release, clients are blocked from using an access category when you
select Enable for Admission Control.