Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 369)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 369
Configuring Authentication Types Chapter 12
6. Configure a TKIP MIC failure holdtime.
countermeasure tkip hold-time seconds
If the access point detects two MIC failures within 60 seconds, it blocks all
the TKIP clients on that interface for the holdtime period.
7. Return to privileged EXEC mode.
end
8. (Optional) Save your entries in the configuration file.
copy running-config startup-config
Use the no form of these commands to reset the values to default settings.
TIP If you configure both MAC address authentication and EAP authentication for
an SSID, the server sends the Session-Timeout attribute for both MAC and EAP
authentications for a client device. The access point uses the Session-Timeout
attribute for the last authentication that the client performs.
For example, if a client performs MAC address authentication and then
performs EAP authentication, the access point uses the server’s Session-
Timeout value for the EAP authentication.
To avoid confusion when using a Session-Timeout attribute, configure the
same Session-Timeout value on your authentication server for both MAC and
EAP authentication.