Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 260)

260 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 7 Configuring Radio Settings
Radio AIR-RM1251A, Base Address 011.9290ec0, BBlock
version 0.00, Software version 6.00.0
Serial number FOCO83114WK
Number of supported simultaneous BSSID on
Dot11Radio1: 8
Carrier Set: Americas (OFDM) (US )
Uniform Spreading Required: Yes
Current Frequency: 5300 MHz Channel 60 (DFS
enabled )
Current Frequency: 5300 MHz Channel 60 (DFS
enabled)
Allowed Frequencies: 5180(36) 5200(40) 5220(44)
5240(48) *5260(52) *5280(56) *53
00(60) *5320(64) *5500(100) *5520(104) *5540(108)
*5560(112) *5580(116) *5660(13
2) *5680(136) *5700(140) 5745(149) 5765(153)
5785(157) 5805(161)
* = May only be selected by Dynamic Frequency
Selection (DFS)
Listen Frequencies: 5170(34) 5190(38) 5210(42)
5230(46) 5180(36) 5200(40) 5220(4
4) 5240(48) 5260(52) 5280(56) 5300(60) 5320(64)
5500(100) 5520(104) 5540(108) 55
60(112) 5580(116) 5600(120) 5620(124) 5640(128)
5660(132) 5680(136) 5700(140) 57
45(149) 5765(153) 5785(157) 5805(161) 5825(165)
DFS Blocked Frequencies: none
Beacon Flags: 0; Beacons are enabled; Probes are
enabled
Current Power: 17 dBm
Allowed Power Levels: -1 2 5 8 11 14 15 17
Allowed Client Power Levels: 2 5 8 11 14 15 17
...
Configuring a Channel Use the channel command to configure a channel. The command for the
interface is modified only to let you select a specific channel number and to
enable DFS.
1. Enter global configuration mode.