Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 427)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 427
Configuring RADIUS and TACACS+ Servers Chapter 14
You can find a list of ISO and ITU country and area codes at the ISO and ITU
websites. Cisco IOS software does not check the validity of the country and area
codes that you configure on the access point.
Beginning in privileged EXEC mode, follow these steps to specify WISPr
RADIUS attributes on the access point:
1. Enter global configuration mode.
configure terminal
2. Specify the WISPr location-name attribute.
The WISPr Best Current Practices for Wireless Internet Service Provider
(WISP) Roaming document recommends that you enter the location
name in this format:
hotspot_operator_name,location
snmp-server location location
3. Specify ISO and ITU country and area codes that the access point includes
in accounting and authentication requests.
isocc, ISO-country-code
Specifies the ISO country code that the access point includes in
RADIUS authentication and accounting requests
cc, country-code
Specifies the ITU country code that the access point includes in
RADIUS authentication and accounting requests
• ac, area-code
Specifies the ITU area code that the access point includes in RADIUS
authentication and accounting requests
dot11 location isocc ISO-country-code cc country-
code ac area-code
4. Return to privileged EXEC mode.
end
5. Verify your settings.
show running-config
6. (Optional) Save your entries in the configuration file.
copy running-config startup-config