Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 246)

246 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 7 Configuring Radio Settings
Radio Tracking You can configure the access point to track or monitor the status of one of its
radios. It the tracked radio goes down or is disabled, the access point shuts down
the other radio. If the tracked radio comes up, the access point enables the other
radio.
• To track radio 0, enter the following command:
# station-role root access-point fallback track d0
shutdown
• To track radio 1, enter the following command:
# station-role root access-point fallback track d1
shutdown
This command is not supported by 802.11n series access points, you must
use the following command in the radio interface configuration mode:
# station-role root access-point fallback shutdown
Fast Ethernet Tracking You can configure the access point for fallback when its Ethernet port is disabled
or disconnected from the wired LAN. You configure the access point for fast
Ethernet tracking as described in the
Universal Workgroup Bridge Mode on
page 245 .
• To configure non-802.11n access points for Fast Ethernet tracking, in the
radio interfaces configuration mode enter the following command:
# station-role root access-point fallback track fa
0
• To configure 802.11n access points for Gigabit Ethernet tracking, in the
radio interfaces configuration mode enter the following command:
# station-role root fallback shutdown
TIP Fast Ethernet tracking does not support the Repeater mode.