Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 253)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 253
Configuring Radio Settings Chapter 7
Configuring Radio Transmit
Power Radio transmit power is based on the type of radio or radios installed in your
access point and the regulatory domain where it operates.
Use this table to determine what transmit power, and the translation relationship
between mW and dBm.
Beginning in privileged EXEC mode, follow these steps to set the transmit power
on access point radios.
1. Enter global configuration mode.
configure terminal
2. Enter interface configuration mode for the radio interface.
• The 2.4 GHz radio is radio 0, and the 5 GHz radio is radio 1.
• The 2.4 GHz 802.11n radio is 0, and the 5 GHz 802.11n radio is 1
interface dot11radio {0 | 1}
3. Set the transmit power for the 802.11b, 2.4 GHz radio or the 5 GHz radio
to one of the power levels allowed in your regulatory domain.
power local
These options are available for the 802.11b, 2.4 GHz radio (in mW):
{ 1 | 5 | 20 | 30 | 50 | 100 | maximum }
These options are available for the 5 GHz radio (in mW):
{ 5 | 10 | 20 | 40 | maximum }
These options are available for the 802.11a, 5 GHz radio (in dBm):
{-1 | 2 | 5 | 8 | 11 | 14 | 15 | 17 | maximum }
These options are available for the 2.4 GHz 802.11n radio (in dBM):
{ -1 | 2 | 5 | 8 | 11 | 14 | 17 | 20| 23 | maximum }
These options are available for the 5 GHz 802.11n radio (in dBm):
{ -1 | 2 | 5 | 8 | 11 | 14 | 17 | 20 | maximum }
4. Set the transmit power for the 802.11g, 2.4 GHz radio to one of the power
levels allowed in your regulatory domain. Settings are in dBm.
On the 2.4 GHz, 802.11g radio, you can set Orthogonal Frequency Division
Multiplexing (OFDM) power levels and Complementary Code Keying (CCK)
Table 83 - Translation Between mW and dBm
dBm -1 2 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
mW 1 2 3 4 5 6 8 10 12 15 20 25 30 40 50 60 80 100 125 150 200 250