Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 167)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 167
Stratix 5100 Device Manager Parameter Definitions Chapter 4
Software Upgrade HTTP Page
An HTTP upgrade requires you to load the image into the access point memory.
If there is not enough system memory for an HTTP upgrade, the upgrade fails. If
it fails, try using TFTP upgrade or upgrading HTTP again after disabling the
radio interfaces, shutting off high memory usage features (such as WDS), and
rebooting.
Figure 81 - Software Upgrade HTTP Page
Table 66 - Software HTTP Upgrade Page Parameter Descriptions
Parameter Description
System Software Filename The software that is installed on the system.
System Software Version The version of Cisco IOS software that is running on the access point.
Bootloader Version The version of bootloader that is installed. The bootloader does not change when the
system image is changed.
Upgrade System Software
Tar File To install a newer version of Cisco IOS software, follow these steps:
1. Insert the correct path and filename of the new system software tar file.
2. Go to Cisco.com and download the newest system software version to your local
drive.
3. Click Browse, locate the new system software file.
4. Click Upgrade to copy the file to the access point.
Upgrades can take several minutes to complete and can cause the access point to
reboot.