Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 284)

284 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 8 Configuring Multiple SSIDs
Use the no form of the command to disable the SSID or to disable SSID features.
This example shows how to:
• Name an SSID.
• Configure the SSID for RADIUS accounting.
• Set the maximum number of client devices that can associate by using this
SSID to 15.
• Assign the SSID to a VLAN.
• Assign the SSID to a radio interface.
AP# configure terminal
AP(config)# dot11 ssid batman
AP(config-ssid)# accounting accounting-method-list
AP(config-ssid)# max-associations 15
AP(config-ssid)# vlan 3762
AP(config-ssid)# exit
AP(config)# interface dot11radio 0
AP(config-if)# ssid batman
AP(config-if)#end
Viewing SSIDs Configured Globally
Use this command to view configuration details for SSIDs that are configured
globally:
AP# show running-config ssid ssid-string
Using Spaces in SSIDs
In Cisco IOS Release 12.3(7)JA and later, You can include spaces in an SSID, but
trailing spaces (spaces at the end of an SSID) are invalid. However, any SSIDs
created in previous versions having trailing spaces are recognized. Trailing spaces
make it appear that you have identical SSIDs configured on the same access
point. If you think identical SSIDs are on the access point, use the show dot11
associations privileged EXEC command to check any SSIDs created in a previous
release for trailing spaces.