Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 75)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 75
Stratix 5100 Device Manager Configuration Startup Chapter 3
Deleting an HTTPS Certificate The access point generates a certificate automatically when you enable HTTPS.
However, if you need to change the fully qualified domain name (FQDN) for an
access point, or you need to add an FQDN after enabling HTTPS, you can
delete the certificate. Follow these steps to delete the certificate.
1. Browse to the Services>HTTP page.
2. Uncheck the Enable Secure (HTTPS) Browsing check box to disable
HTTPS.
3. Click Delete Certificate.
4. Re-enable HTTPS.
The access point generates a new certificate by using the new FQDN.
Disabling the Web Browser
Interface To prevent all use of the web browser interface, check the Disable Web-Based
Management checkbox on the Services: HTTP-Web Server page and click Apply.
To re-enable the web browser interface, enter this CLI global configuration
command.
ap(config)# ip http server