Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 514)

514 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 19 Configuring SNMP
Configuring SNMP-Server Hosts
To configure the recipient of an SNMP trap operation, use the following
command in global configuration mode:
snmp-server host host [traps | informs][version {1
| 2c | 3 [auth | noauth | priv]} ] community-string
[udp-port port] [notification-type]
Configuring SNMP-Server Users
To configure a new user to an SNMP group, use the following command in global
configuration mode:
snmp-server user username [groupname remote ip-
address
[udp-port port] {v1 | v2c | v3 [encrypted] [auth
{md5 | sha} auth-password [priv des56 priv
password]] [access access-list]
Configuring Trap Managers and Enabling Traps
A trap manager is a management station that receives and processes traps. Traps
are system alerts that the access point generates when certain events occur. By
default, no trap manager is defined, and no traps are issued.
Access points running this Cisco IOS release can have an unlimited number of
trap managers. Community strings can be any length.
This table describes the supported access point traps (notification types). You can
enable any or all of these traps and configure a trap manager to receive them.
Table 111 - Supported Access Point Traps
Notification Type Description
authenticate-fail Enable traps for authentication failures.
config Enable traps for SNMP configuration changes.
deauthenticate Enable traps for client device deauthentications.
disassociate Enable traps for client device disassociations.
dot11-qos Enable traps for QoS changes.
entity Enable traps for SNMP entity changes.
rogue-ap Enable traps for rogue access point detections.
snmp Enable traps for SNMP events.
switch-over Enable traps for switch-overs.
syslog Enable syslog traps.
wlan-wep Enable WEP traps.