Network interface gigabitethernet status page – Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual User Manual
Page 91

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
91
Stratix 5100 Device Manager Parameter Definitions
Chapter 4
Network Interface GigabitEthernet Status Page
Use this page to review the status for the GigabitEthernet interface.
Figure 37 - Network Interface GigabitEthernet Status Page
Table 16 - GigabitEthernet Status Parameter Descriptions
Parameter
Description
Configuration
Software Status
Indicates whether the interface has been enabled or disabled by the operator.
Hardware Status
Indicates whether the line protocol for the interface is up or down.
Maximum Rate
The rate setting for the Ethernet interface, either 10 Mbps or 100 Mbps.
Duplex
The duplex setting for the Ethernet interface, either half or full.
Interface Statistics
Interface Resets
The number of times an interface has been completely reset.
No Carrier
The number of times the carrier was not present during the transmission.
Lost Carrier
The number of times the carrier was lost during transmission.