Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 185)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 185
Configure the Stratix 5100 WAP Using the Command-Line Interface Chapter 5
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
!
interface Dot11Radio1 /1
no ip address
no ip route-cache
!
ssid no_security_ssid
!
speed basic-6.0 9.0 basic-12.0 18.0 basic-24.0 36.0
48.0 54.0
rts threshold 2312
station-role root
!
interface Dot11Radio1 /1 .10
encapsulation dot1Q 10 native
no ip route-cache
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
For the instructions in Device Manager, see Configuring Security on page 64 .
By selecting No Security, all the other settings in this CLI example are just the
defaults set by Device Manager