Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 89)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 89
Stratix 5100 Device Manager Parameter Definitions Chapter 4
Last Output Hang The number of hours, minutes, and seconds (or never) since the interface was last reset because of a transmission that took too long. When
the number of hours in the Time Since Last Input, Time Since Last Output, or Last Output Hang fields exceeds 24 hours, the number of days
and hours is printed.
Lost Parent Counts
(Repeater Mode Only) • No beacons
The number of times the repeater stopped receiving beacons from the parent. The parent access point is probably out of range. Average
retry level
• Deauthenticated
The number of times the repeater received a deauthenticate packet from the parent.
• Disassociated
The number of times the repeater received a disassociate packet from the parent access point.
• Time lost base
The number of times the time base broadcast of the repeater changed to an amount that was too large. The parent access point
probably restarted.
• Host request
The number of times the link between the repeater and the parent access point was restarted. The operator changed the assigned
parent.
• Better parent found
The number of times the repeater switched to a new parent access point because the signal from the current parent was getting weak.
Association Statistics
(Repeater Mode Only) If the repeater is not associating to a parent, note these statistics.
• SSID mismatched
The number of times the repeater received a beacon or probe response that did not match the requested SSID.
• Not specified AP
The number of times the repeater received a response from a parent that has not been configured in the list of parents.
• Rates mismatched
The number of times the repeater received a response from a parent that does not support the rates that were requested.
• Privacy mismatched
The number of times the repeater received a response from a parent that does not support the privacy settings that were requested.
• Authentication rejects
The number of times the repeater received an authentication response from a parent containing a unsuccessful status.
• Association timeout
The number of times the repeater did not receive an associate request response from a parent access point.
Table 14 - System Setting Parameter Descriptions (Continued)
System Settings Description