Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 226)

226 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 6 Administering the WAP Access
5. Configure the duration of the lease for IP addresses assigned by the
wireless device.
• days, configure the lease duration in number of days
• (optional) hours, configure the lease duration in number of hours
• (optional) minutes, configure the lease duration in number of minutes
• infinite, set the lease duration to infinite
lease { days [ hours ] [ minutes ] |
infinite }
6. Specify the IP address of the default router for DHCP clients on the
subnet. One IP address is required; however, you can specify up to eight
addresses in one command line.
default-router address [address2 ... address 8]
7. Return to privileged EXEC mode.
end
8. Verify your entries.
show running-config
9. (Optional) Save your entries in the configuration file.
copy running-config startup-config
Use the no form of these commands to return to default settings.
This example shows how to configure the wireless device as a DHCP server,
exclude a range of IP address, and assign a default router:
AP# configure terminal
AP(config)# ip dhcp excluded-address 172.16.1.1
172.16.1.20
AP(config)# ip dhcp pool wishbone
AP(dhcp-config)# network 172.16.1.0 255.255.255.0
AP(dhcp-config)# lease 10
AP(dhcp-config)# default-router 172.16.1.1
AP(dhcp-config)# end