Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 329)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 329
Configure an Access Point as a Local Authenticator Chapter 10
9. Enter the port number your RADIUS server uses for accounting.
The port setting for Cisco's RADIUS server (the Access Control Server
[ACS]) is 1646, and the port setting for many RADIUS servers is 1813.
Check your server's product documentation to find the correct accounting
port setting.
10. Use the pull-down menus to determine the level of priority you want to
assign to each server.
11. Click Apply to add the server.
Steps step 12 through step 17 are optional tasks and can be skipped to
expedite setup.
12. Click the Global Properties tab.
13. Specify the interval that the accounting updates are performed in the
Accounting Updates Interval field.
14. In the TACACS+ Server Timeout field, specify the number of seconds an
access point waits for a reply to a TACACS+ request before resending the
request.
15. In the RADIUS Server Timeout field, specify the number of seconds an
access point waits for a reply to a RADIUS request before resending the
request.
16. In the RADIUS Server Retransmit Retries field, specify the number of
times the access point sends each RADIUS request to the server before it
stops trying.
If more than one RADIUS server is configured for EAP authentication,
enable the Dead Server List option. Specify how long unresponsive
RADIUS servers should be skipped over when the access point is
attempting RADIUS server authentication. Enter this amount in the
Server remains on list for text field.
17. Click Apply in the Global Server Properties section.